#1001 Brush Grade Caulk

DESCRIPTION
SEALMARK  #1001 Brush Grade Caulk is a water-based acrylic resin blend, thixothropic coating. This product contains fine aggregate and complex fillers that are used to fill and seal hairline cracks and the surface transition point between the wall substrate and the foam or wood trim.

 

USES
SEALMARK  #1001 Brush Grade Caulk is used to fill and level hair line cracks and cracks up to 1/8 inch in width.  #1001 is also used in the Sealmark TEF’s system to seal the transition point where the foam or wood trim pieces are installed on the wall.  Sealmark #1001 can be used to seal minor cracks in metal and wood before coating.

COVERAGE
The coverage rates for SEALMARK  #1001 Brush Grade Caulk  will vary greatly depending upon the width and depth of the crack.  When brushing the #1001 into the transition point between the wall and the trim piece coverage rate will be approximately 400 lineal feet per gallon of product.

 

APPLICATION PROCEDURES
Substrate Preparation - Surfaces must be clean, dry, structurally stable.  It is recommended the Sealmark Primer be used to treat the surface before the brush grade caulk is applied, but it is not necessary to achieve a bond between the substrate and the caulking.  Substrate surface temperature should be at least 40 F and free of grease, oil, dirt, and other solvents that would interfere with the surface bond. 

Application - Brush #1001 into crack or joint area in a continuous film; be sure to fill the crack with no voids.  For cracks on smooth surface walls use a putty knife to push excess material into crack and level surface.  Remove excess material from sides of filled crack with a damp sponge taking care not to wipe material out of filled crack.  After excess is cleaned away retool with putty knife.  For rough wall surface complete the same method as for smooth wall surface but stipple the repair with a soft brush to match the existing surface.

 

Click here to download the Material Safety Data Sheet (MSDS) for this product.